Chevy Avalanche Replacement Remote Programming 2007 2010

1 views

0   0

Visit us at http://www.carandtruckremotes.com/


Instructions for Chevy Avalanche Replacement Remote Programming 2007 2010

Switch Avalanche ignition ON.

Repeatedly press vehicle information button (it is usually located on the right or left from the steering column depending on year make and model) Fig. 2 [A] until PRESS TO RELEARN REMOTE KEY is displayed.

Press set/reset button Fig. 2 [B] until REMOTE KEY LEARNING ACTIVE is displayed.

Programming mode activated, proceed as follows:

Press and hold LOCK and UNLOCK Avalanche remote buttons on first remote transmitter simultaneously for 15 seconds.

Wait for acoustic signal (indicates correct programming).

Repeat above procedure to program remaining Avalanche remote transmitters.

Switch ignition OFF to exit programming mode.

Remote transmitters can also be programmed using diagnostic equipment.

NOTE: A maximum of 8 remote transmitters can be programmed.
View More
test 728
Comments

0 Comments